Cascade Control - I don't know what's wrong?!

[Donald C.]

Ok so I have been working on this control for quite sometime and I can " load " it to the top easily now 10/10 times. But I dont know whats wrong where ever I am I flash. I have tried so many different and tried to rework it. Can someone please give me some pointers. I have on demand from Dan andDave. I am stuck on this.
Please help

 

[Retype.SW]

Keep it as tight as you can. As soon as it is stripped out, do the Cascade and don't move your hand any higher. I had the same trouble as you and this is what sorted mine out, hopefully it will sort your too.

 

[Axe]

I have the same problem as well also, after the step, there is 1 card that is up too high before the waterfall, and you can see the card above the selection. Then when I go to waterfall the remaining cards, the cards waterfall over the*card* and then, obviously no control. lol

Any tips for this would be very much appreciated, I love the way it looks when i see other people execute it, and I really want to get this down.=)

-Alex

 

[MagicShadow9]

I really dont understand what you're trying to say. But i once hand a problem where the selected card was flopping around during the waterfall so it was easy to easy the card was coming to the top. I fixed it by asking on the dan and dave forums and someone told me to keep pressure with the pinky finger so the card stays in place and doesn't flop around.

i dont know if that's your problem tho.

 

[Axe]

Im trying not to reavel so, it might be confusing ha sorry=/ But anyway, the place with the break,after the step of the upper half of the pack,about the selection. The card above the break shows when you turn to perform the waterfall shuffle. And the other problem is that, When you waterfall the cards, the selection ends up almost flat, and when you go to square up(after the waterfall) a small portion of the card can be seen.


-Alex

 

[Donald C.]

Thank you all for the help.